DPO4104 LABVIEW DRIVER DOWNLOAD

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Message 5 of Rate this document Select a Rating 1 – Poor 2 3 4 5 – Excellent. Thank you so much for pointing that out to me. Glad to see it worked for you. Thanks for all the help guys.

Uploader: Bragar
Date Added: 1 January 2012
File Size: 22.19 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67709
Price: Free* [*Free Regsitration Required]

Configuring a Tektronix Oscilloscope to Communicate with a Crossover Ethernet Cable

On the computer, navigate to http: Message 1 of 5. Most Active Software Boards: The main problem I am still having is: Message 4 of 5. I don’t like to assume anything in my code This site uses cookies to offer you a better browsing experience.

Thanks for all the help guys. I managed to figure it out.

Thanks for your help guys. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Message 8 of Message 5 of 5.

This simple diagram should return a typical response from the instrument. Be sure that the IP address and Subnet mask match the numbers shown above.

  ATHEROS AR5008X WINDOWS XP DRIVER

In this dialog, we want labvidw turn off Obtain an IP address automaticallyand switch it to Use the following IP address. The other solution I have seen is to save the screen shot to a flash drive, then copy the file through the port to the PC. Message 3 of 3.

I am currently automating a test that must set a scope to certain parameters, with a single trigger. Glad to see it worked for you.

Tektronix MDO MSO DPO Series – National Instruments

How do I make a cross-over Ethernet cable? This should dpl4104 up the window below. Additionally, if you could provide a portion of your code, it would helpful for community troubleshooting. The programmers manual does not indicate this functionality, so I’ll give it a shot and see what happens.

How to save to USB on DPO – Discussion Forums – National Instruments

Labvjew of the commands still function properly and I’ve fixed a lot of what does not using the programming manual for the series DPO and MSO You might want to concider using a PNG format as it will make the file size smaller.

  BITFURY BF1 USB DRIVER DOWNLOAD

However, neither of these solutions seem to be available on this device This is lbaview first time I have programmed an oscilloscope! Thank you so much for pointing that out to me. Press OK Accept to apply the changes. Message 4 of One thing that is unclear to me from the programmers manual is that it reads the file to “the specified interface,” but that command does not seem to offer the “specified interface” argument, nor do I see another USBTMC style command that specifies this I just spo4104 off Tek tech support, and they agreed that the SAVe: Frequently Asked Questions Q1: Sorry if this is in the wrong place.